Butterfly valves are integrally moulded and are offered in a variety of elastomer-disc combinations to accommodate a wide range of process requirements.

A motorised butterfly valve is a quarter turn valve, which implies that in order to start or halt fluid flow, the valve disc must be angled at a 90 degree angle.

Digital Handwheel Balancing Valve is used to balance the chilled water system and regulate the flow of water. Before the fluid enters the unit, it is utilised to adjust the flow. The handwheel functions as an integrated flow metre so that the valve's operation may be precisely viewed and recorded.

The Dual Plate Check Valve is an all-purpose non-return valve that is significantly stronger, lighter in weight, and smaller in size in comparison to a swing check valve or life check valve. Two spring-loaded plates are used in the Double Plate Check Valve, which is hinged on a central hinge pin.

A Single Plate Check Valve is used to prevent fluid backflow in a pipeline arrangement. To form a non-return valve, it is commonly fastened to two sections of flanged piping.

Test and Drain Valves are small, three-position ball valves with a K-factor of 5.6 on the drain orifice and a sight glass . Test and drain valves are used in wet sprinkler systems for both express draining and testing.

To automatically bleed air from the heating system, the Automatic Air Vent is fitted on the heating system, often inside cylinder cupboards. A basic valve and a polypropylene float make up the apparatus.

Using a hollow, perforated, pivoting ball, a ball valve is a flow control device that regulates the flow of liquid through it. The valve is open when the ball's hole is parallel to the flow inlet.

Using a hollow, perforated, pivoting ball, a ball valve is a flow control device that regulates the flow of liquid through it. The valve is open when the ball's hole is parallel to the flow inlet.

An Extended Stem Ball Valve lengthens a valve stem so that the operational device can be brought close to the surface without the need of a heavy, long valve that is struggling to locate the operating device.

A Pressure-Reducing Valve is used to lower any excess pressure in a system. Pressure-reducing valves' primary purpose is to transform increased pressure into lower pressure.

A butterfly valve is a type of valve used to control or isolate fluid flow. An rotating disc acts as the closing mechanism.